Seat Belts - Winnebago Chalet 27CR2006 Manual

Class A
Lift to Slide
Passenger Seat - Aisle Side
(Recline lever on opposite side)
WARNING
Do not adjust driver's seat while vehicle is
in motion.
After adjusting seat, always use body
pressure to make sure slide and swivel
locking mechanism have engaged.
Arm Rest Adjustment
The driver and co-pilot seat armrests may be
adjusted to rest at two different positions as
shown.
Position 1 - Raise armrest, push in toward seat,
and lower into position. This position would
generally be used when the seat is in the
upright position.
Position 2 - Raise armrest, pull outward from
seat, and lower into position. You may wish
to use this position when you recline the seat.
– Getting To Know Your MotorHome
Lift to Swivel

SEAT BELTS

Seats intended for occupancy while the
vehicle is in motion are equipped with seat belts
for the protection of the driver and passengers.
Lap Belts
The lap belts must be worn as low as possible
and fit snugly across the hip area. Always sit
erect and well back into the seat. To gain full
protection of the safety belt, never let more than
one person use the same safety belt at any one
time, and do not let the safety belts become
damaged by pinching them in the doors or in the
seat mechanism. After any serious accident, any
seat belts which were in use at the time should be
replaced.
3
2
1
1 .
2 .
3 .
Adjustment: To lengthen belt, turn tongue at a
right angle to belt and pull to desired length.
To shorten, pull loose end of belt.
To Fasten: Be sure belt is not twisted. Grasp
each part of the belt assembly and push
tongue into buckle. Adjust to a snug fit by
pulling the loose end away from the tongue.
To Release: Press button in center of buckle and
slide tongue out of buckle.
SECTION 3
1
2
P U L L T O T I G H T E N .
T O N G U E .
P U S H T O R E L E A S E .
3-5