Table of Contents
Advertisement
How to Set the Cutting Speed
(1) Close the front cover and press the
(2) Use the
and
keys to change the value, then press the
(3) To adjust speed during tool-up time or to adjust cutting quality, press the
Use the
and
keys to change the value (or the selection) and enablethe setting by pressing the
Adjust Speed During
Tool-up Time
Setting range: 1—85 cm/s.
For more information, see "8 Display Menu Lists."
4-2 Loading the Material
Roll material must be placed at a
predetermined shaft position.
Failure to do so may
result in falling of the
roll, leading to injury.
Width (horizontal dimension) and maximum cutting width
Acceptable material widths
CM-500
Min.90 mm (3-1/2")
CM-400
Min.90 mm (3-1/2")
CM-300
Min.50 mm (2")
( 50—540 mm (2"—21" ) , 582—915 mm (23"—36" ) )
There is no special restriction on length (vertical dimension), as long as it is 200 mm (7-1/4") or more.
This means that you can use either flat materials such as standard-size materials (ANSI, ISO, etc.) and cut materials, or roll materials.
The grit rollers (pinch rollers that secure the material) vary from one model to another, and settable ranges are determined for the left
and right movable pinch rollers. See "Material Loading Position" on the next page.
Setting a pinch roller outside the allowed range causes an error message to appear.
key until the message shown below appears.
1 CUT
50cm/s
0.250mm
30gf
UP50cm/s
(in increments of 1 cm/s.)
Max.1372 mm (54")
Max.1178 mm (46")
Max.915 mm (36")
Cutting Speed
Setting range: 1—85 cm/s.
key to accept the value.
key until the screen shown below appears.
Cut Quality
NORMAL
Setting range: NORMAL/HEAVY/HI-SPEED
(in increments of 1 cm/s.)
key.
Maximum cutting area
1195 mm (47")
1000 mm (39")
737 mm (29")
13
Hide quick links:
Advertisement
Table of Contents
