Table of Contents
Advertisement
9
Close the front cover.
Use the
and
keys to select [Roll], then press the
* If cutting is to be performed from the front edge of the material, select
"EDGE."
10
Press the
key. The SETUP LED lights up, and the horizontal width of the
material is detected and shown on the display.
* If "EDGE" has been selected for the material, then after the width of the
loaded material is detected, the front edge of the material is aligned with the
cutting-start area.
If a pinch roller is positioned over an area where there is no grit roller, the
message shown at right appears when you press the
If this occurs, lower the sheet loading levers and move the pinch rollers to the
proper positions above the grit rollers.
Reposition the material to match this new alignment, then lower the sheet
loading levers to hold the material in place.
11
Press the
key once to display the top menu.
12
(1) Press the
(2) Use the
and
key.
(3) Move the blinking cursor to the numerical value under [LENGTH]. Use the
and
keys to set the required material length for cutting. Set this to a value
that's about 0.1 m longer than the length of the cutting data.
Press
key to fix the displayed values.
(4) Use the
and
key. The material is fed out by the length set for [LENGTH].
If the material is misaligned and looks like it might come loose from the pinch
rollers, or actually does come loose, please reload the material.
key on the top menu once.
key to move the blinking cursor to [AREA], then press the
keys to move the blinking cursor to [MOVE], then press the
key.
key.
Close the front cover
SELECT SHEET
ROLL EDGE PIECE
PRESS SETUP KEY
WIDTH LENGTH
28920
---
Change Pinch
Roller Position
Top menu
1 CUT
50cm/s
0.250mm
30gf
Press
once.
AREA
AXIS
REPLOT
SUBMENU
Use
or
to select.
Press
.
AREA
LENGTH
MOVE
< 5.0m>
Use
or
to change the
value.
Use
or
to select "MOVE."
Press
.
17
Hide quick links:
Advertisement
Table of Contents
