What To Know Before Cutting; Useable Material Types - Roland Stika SV-15 User Manual

3-1 What to Know Before Cutting

Useable Material Types

T h e f o l l o w i n g m a t e r i a l s c a n b e u s e d w i t h t h i s m a c h i n e .
Size
280 to 305 mm (11 to 12 in.)
Material Types Vinyl chloride material (material section thickness is 0.1 mm or less, thickness including the backing
(*) paper is 0.3 mm (0.012 in.) or less)
Label paper (Thickness including backing paper is 0.3 mm (0.012 in.) or less)
* T h e m a c h i n e m a y n o t c u t c e r t a i n m a t e r i a l s .
➢Do not use material that is in a condition indicated below. It may come loose or jam during cutting.
The material is
curled upward.
Using Roll Material
If you're using a roll of material, make sure to add a margin greater than 40 mm (1-5/8 in.) to the cutting area
prior to cutting the material from the roll. Material with a maximum length of 1100 mm (43-1/4 in.) can be loaded
into the machine. However, the cutting area is only 1000 mm (39-5/16 in.).
➢Cut the material at a right angle. If the front edge of the material is uneven, it may feed improperly during
cutting and could skew diagonally and come loose.
26 Chapter 3: Performing Cutting
SV-15
Width: 360 to 381 mm
(14-1/8 to 15 in.)
(A3 length, A4 width)
Length: 1100 mm
(43-1/4 in.) or less
The material edge is
not straight
SV-12
Width: 280 to 305 mm
(11 to 12 in.)
(A3 length, A4 width)
Length: 1100 mm
(43-1/4 in.) or less
The left and right
edges of the material
aren't parallel
Up to
1100 mm
(43-1/4 in.)
SV-8
Width: 200 to 215 mm
(7-13/16 to 8-7/16 in.)
(A4 length)
Length: 1100 mm
(43-1/4 in.) or less
The material is longer than
1100 mm (43-1/4 in.)