Key Digital KD-IP922ENC Operating Instructions Manual page 20

36
<stop bit> RS-232 stop bit setting
<parity> RS-232 parity type
<time interval> / This value sets the time interval /
<timeout> timeout value for a port timer.
-For Trigger usage, time interval is the
frequency that the port will return its
current sensed voltage state.
-For RS-232 usage, timeout is the
amount of time in milliseconds that Rx
data is stored in the buffer
<TCP port> TCP port number
<port level> Trigger port level
1:
1 stop bit.
1.5:
1.5 stop bits.
2:
2 stop bits.
PAR_NONE:
No parity.
PAR_ODD:
Odd parity.
PAR_EVEN:
Even parity.
PAR_MARK:
Parity force to 1(Mark).
PAR_SPACE:
Parity force to 0(Space).
PAR_MULTIDROP:
Multidrop mode.
From 0 to 65535 milliseconds
From 0 to 65535
LEVEL_HIGH:
I/O port trigger input pin is
high state.
LEVEL_LOW:
I/O port trigger input pin is low
state.
<set level> Trigger level to set
<CFG_RSP> Standard configuration command
response
<port mode> Port mode
Possible Responses
Response Meaning
ERR_OK Command executed successfully
ERR_CMD Command not recognized
ERR_PORT I/O Port doesn't match the command received
ERR_PARAM Bad parameter in command
ERR_MODE I/O Port doesn't match the command received
ERR_CONF Port not configured for KeyCode Open API Mode
LEVEL_HIGH Trigger Input High Level
LEVEL_LOW Trigger Input Low Level
37
HIGH:
Change I/O port trigger output
pin to high state.
LOW:
Change I/O port trigger output
pin to low state.
See table below: "Possible
Responses"
IRL:
I/O port is IR Sensor mode.
IRIN:
I/O port is Serial IR Input
mode.
IROUT:
I/O port is IR Output mode.
RS:
I/O port RS-232 mode.
TR:
IO port is Trigger Input/output
mode.