Hilti TE 40 Manual page 10

5.1.3 Removing the chuck
CAUTION
Risk of injury! The depth gauge, if fitted but not used, may hinder the user.
▶ Remove the depth gauge from the tool.
Note
To change the chuck, set the function selector switch to this position
1. Disconnect the supply cord plug from the power outlet.
2. Grip over the end of chuck and pull the chuck release collar upwards.
3. Lift the chuck upwards away from the tool.
5.1.4 Fitting the chuck
CAUTION
Risk of injury! The depth gauge, if fitted but not used, may hinder the user.
▶ Remove the depth gauge from the tool.
Note
Set the function selector switch to the
1. Disconnect the supply cord plug from the power outlet.
2. Grip over the end of the chuck and pull the chuck release collar upwards.
3. Fit the chuck onto the chuck mount.
4. Rotate the chuck until it engages in position.
8 English
Printed: 17.03.2017 | Doc-Nr: PUB / 5142305 / 000 / 01
"Chiseling" position when changing the chuck.
.