Toshiba MMU-AP0072H2UL-1 Service Manual page 70

How to change an indoor unit address by using a wired remote control
Use this method to change the address of indoor units (one to one or group control) that have had the original
address set automatically.
This procedure must be done while the units are not operating.
1
Simultaneously push and hold the "SET
seconds. If there are 2 or more units in a group, the first "UNIT No." indicated is the header
unit.
2
Push button (button of left side) repeatedly to select an indoor unit address to change. If
UNIT LOUVER
2 or more units are controlled in a group the fan and louvers of the selected unit will be ener-
gized.
3
Push the TEMP.
4
Push the TIME
tion.
5
Push the "SET
SET
6
Push button (button of left side) repeatedly to select another indoor unit addresses to
UNIT LOUVER
change. Repeat steps 4 through 6 to continue changing indoor unit address and make each of
them unique.
7
Push button (button of left side) to review/confirm the revised addresses.
UNIT LOUVER
8
If the addresses have been changed correctly, push the "TEST
dure.
/ buttons repeatedly to select
/ buttons repeatedly to change the value indicated in the SET DATA sec-
" button, to save address.
SET DATA
TEMP.
3
5
FILTER
RESET TEST
8
Finish
1
CL
", "CL ", and "TEST
SET
13 13 13 13 13
for CODE No..
CODE No.
SETTING
UNIT No.
R.C. No.
ON / OFF
TIMER SET
TIME
SET CL
2, 6, 7
70
" buttons for more than 4
TEST
" button to finish the proce-
TEST
4