Toshiba MMU-AP0072H2UL-1 Service Manual page 39

6-2. High Wall Type
No. Item
1 When power
supply is reset
2 Operation
mode selection
3 Room temp.
control
4 Automatic
capacity control
5 Air speed
selection
Outline of specifications
1) Distinction of outdoor unit
When the power supply is reset, the outdoors are
distinguished and the control is selected according to
the distinguished result.
2) If resetting the power supply during occurrence of a
trouble, the check code is once cleared. After ON/OFF
button of the remote control was pushed and the
operation was resumed, if the abnormal status contin-
ues, the check code is again displayed on the remote
control.
1) Based on the operation mode selecting command from
the remote control, the operation mode is selected.
Remote control
command
STOP
FAN
COOL
DRY
HEAT
1) Adjustment range: Remote control setup temperature (°F [°C] )
Wired type 64°F [18°C] to 84°F [29°C]
Wireless type 63°F [17°C] to 86°C [30°C]
2) Using the Item code 06, the setup temperature in
heating operation can be corrected.
Setup data 0
Setup temp. +0°F
Correction [+0°C]
Setting at shipment
Setup data 3
1) Based on the difference between Ta and Ts, the
operation capacity is determined by the outdoor unit.
1) Operation with (HH), (H), (L) or [AUTO] mode is carried
out by the command from the remote control.
For the wireless remote control type, (HH), (H+), (H),
(L+), (L) or [AUTO] operation is carried out.
2) When the air speed mode [AUTO] is selected, the air
speed varies by the difference between Ta and Ts.
Control outline
Air conditioner stops.
Fan operation
Cooling operation
Dry operation
Heating operation
COOL/DRY
2 4
+3.6°F +7.2°F +10.8°F
[+2°C] [+4°C] [+6°C]
39
Remarks
Ta: Room temp.
Ts: Setup temp.
HEAT
64°F [18°C] to 84°F [29°C]
63°F [17°C] to 86°F [30°C]
Shift of suction temperature
in heating operation
6
Except while sensor of the
remote control is controlled
(Code No. [32], "0001")
Ts: Setup temp.
Ta: Room temp.
HH > H+ > H > L+ > L > UL