Toshiba MMU-AP0072H2UL-1 Service Manual page 141

Procedure 3: Writing Setting Data in EEPROM
(The EEPROM of the service P.C. board has been set to the factory default values.)
1
Push the +
corresponds to the same number shown on the Remote Control Operation Diagram.)
ALL
(Under UNIT No.,
At the same time, the CODE No. (DN code)
louver swinging, depending on the model.
2
The button allows you to moved the CODE No. (DN code) up/down by one place.
3
First, set the type and capacity codes of the indoor unit.
(Changing the type and capacity codes in EEPROM overwrites the factory default settings.)
(1) Set the CODE No. (DN code) to 10 (no change)
(2) Use the button to select the type.
0001
(For example,
(3) Push the button. (The display should change from flashing to steady.)
(4) Use the button to set the CODE No. (DN code) to
(5) Use the button to set the capacity code.
(For example, 0012 is for the 027 type.) - See the CODE No. list.
(6) P ush the button. (The display should change from flashing to steady.)
Setting for 4-way Cassette model only
(1) Using the set temperature
(2) Using the timer time
Setting for MMU-AP0072H2UL-1 only
(1) Using the set temperature
(2) Using the timer time
(7) Push button (The setting completes if the setting data are displayed.)
(8) Push the button to bring the system back to normal off state.
4
Next, write any setting changes made on-site after installation, such as address settings, in the
EEPROM. Perform the tasks specified in step 1 again.
5
Use the button to set the CODE No. (DN code) to
6
Check the value displayed with the value jotted down in Procedure 1 and information proved by
the customer.
(1) If there is a discrepancy, change the setting in accordance with the jotted-down value, and push the
(The display should change from flashing to steady.)
(2) If there is no discrepancy, do nothing.
7
Use the button to change the CODE No. (DN code).
Again, check the value, and change the setting if necessary.
8
Repeat steps 6 and 7 until all the settings are checked.
9
When finished, push the
In the case of group operation, turn the unit off, reconnect the indoor-indoor group control wiring and CN41
connectors, and turn on all the indoor units.
(It takes the system about 1 minute to become responsive to remote control operation.)
* CODE No. (DN code) go from
If you realize you have wrongly corrected a certain setting after pushing the
value by pushing the
+ buttons simultaneously and hold for at least 4 seconds.
is displayed.)
4
is for the 4-way air discharge cassette type.) - Refer to the attached table 1.
/ buttons, set "
/ buttons, set
/ buttons, set "
/ buttons, set
button to bring the system back to normal off state.
01 FF
to with a few gaps along the way.
button, provided that the CODE No. (DN code) is yet to be changed.
10
is displayed, and the fan of the indoor unit comes on, with the
11
.
CE
" to the CODE No. (DN).
0000 0001
(initial) to "
CF
" to the CODE No. (DN).
0000 0001
(initial) to "
6
01
(To set filter sign lighting time)
141
1
5
".
".
6
button, you can recover the initial
(This number
3
button.