Toshiba MMU-AP0072H2UL-1 Service Manual page 104

No. Part name
1. Detachment
Drain cap
6
1) Carry out work of Detachment of
2) Loosen screws (3 positions) fixing the drain
NOTE :
The drain cap is hung down because a strap
is attached to it (outside).
3) Loosen the cap by turn the drain cap
NOTE :
Be sure to catch drain water using a bucket,
etc. when loosening the drain cap.
The insulating materials are adhered to the
drain cap (outside) and opening part of the
drain pan; be careful that they are not come off.
If they are come off, stick them as before
using double-faces tape, etc.
4) Turn the drain cap once again to OPEN
2. Attachment
1) Insert the drain cap (inside), turn it to the
NOTE :
When attaching the drain cap (inside),
remove dirt attached to the packing.
And tighten in it noting so that the cap is not
slantingly set.
If attaching the drain cap as dust or dirt is
attached or the cap is set slantingly, water
leakage is caused.
2) Turn the drain cap (outside) to the arrow
3) Following to work of Attachment of
Procedure
cap (outside) and then turn the drain cap to
the arrow mark → (OPEN) direction to
remove it.
(inside) for approx. 1 turn to OPEN →
direction and then drain the drain water
accumulated in the drain pan.
→ direction to remove it.
arrow mark → (CLOSE) direction until the
position where "Clashed sound" is heard
and it cannot be turned more over
(Position where mark of the drain pan
matches with mark of the drain cap
(inside)) and then fix it.
mark → (CLOSE) direction and then attach
it using the fixing screw as before.
mount the suction grille as before.
.
1
CLOSE CLOSE CLOSE
OPEN OPEN OPEN
CLOSE CLOSE
OPEN OPEN
Drain cap Drain cap Drain cap
Replacing antibacterial glass
Request your dealer to replace the
antibacterial glass 10000 hours of
cooling operation.
Part code
,
1
104
Remarks
Drain cap (outside)
Strap Drain cap fixing screws
Drain cap (inside)
Drain pan Drain pan Drain pan
mark mark mark
43179152
mark mark mark