Toshiba MMU-AP0072H2UL-1 Service Manual page 137

No. Part name
<Caution at reassembling>
Cross flow
fan
1) To incorporate the fan motor, remove the
fan motor rubber (at shaft core side),
incorporate the motor into the position in
the following figure, and then install the fan
motor.
• Install the cross flow fan so that the right
• Holding the set screw, install the cross
• Perform positioning of the fan motor as
• When assembling the fan motor, the fan
• After assembling the 2 fixing screws of the
Procedures
end of the 1st joint from the right of the
cross flow fan is set keeping 5 mm from
wall of rear plate of the main unit.
flow fan so that U-groove of the fan motor
comes to the mounting hole of the set
screw.
follows:
motor must be installed in such a way that
the fan motor leads will be taken out is
positioned at the bottom front.
motor band (right) into the main body,
position the fan motor, insert it, and then
secure the motor band (right) using the
2 fixing screws.
137
Remarks
0.2"(5.0mm)