Wiring Diagram For Primary Reporting Configuration Gemc-32, Gemc-96, Gemc-128 And Gemc-255 Control Panels - NAPCO StarLink SLE Installation Instructions Manual

Wiring Diagram for PRIMARY Reporting Configuration
GEMC-32, GEMC-96, GEMC-128 and GEMC-255 Control Panels
RJ31X
TIP RING
RJ31X
TIP RING
*Refer to section
"SUPPLYING POWER".
Special Wiring Instructions for the
GEMC-F8ZCPIM as a Monitor Zone Only
When PGM1 is wired to a GEMC-F8ZCPIM
zone, replace the 2.2k ohm EOL resistor with
a 560ohm 1/2 watt min EOL resistor. Connect
PGM1 to the negative terminal of the zone.
When PGM2 and/or PGM3 are wired to a
GEMC-F8ZCPIM zone, replace the 2.2k ohm
EOL resistor with two 1K ohm 1/4 watt min
EOL resistors. Connect the PGM wire to the
common wire of the two resistors in series.
GEMC-F8ZCPIM
ZONE
(+) (‒)
Radio PGM1 terminal
EOLR 560Ω
(min 1/2W)
14
(Use when telephone line is NOT available)
(CONTROL PANEL HOUSING)
MONITOR ZONE
(+) DEDICATED
TO GPRS
SUPERVISION
1*
+12V
GEMC-F8ZCPIM
ZONE
EOLR EOLR
(STARLINK RADIO HOUSING)
1K Ω 1K Ω
Radio PGM2 or
PGM3 terminal
GEMC Control
Panel PC Board
SEE WIRING
DIAGRAM
AND WI FOR
ADDITIONAL
INFORMATION
10K
2* 3 4 5 6 7
(–) PGM1 PGM2 PGM3 IN1 IN2
StarLink Radio Terminals
All connections are power limited ex-
cept AC Mains, Telco and battery termi-
nals. Terminals 14-17: No connections
™
StarLink SLE Commercial Series Alarm Communicators -- Installation Instructions
8 9 10 11 12 13
PANEL
PANEL
GND IN3 TIP RING
RING (+) TIP (–)
permitted.
14 15 16 17
CTS
PANEL PANEL
RTS
TX (B) RX (G)
Y
(R)