Samsung AE120JXEDEH Installation Manual page 39

Setting the option
1. Press and hold K2 to enter the option setting. (Only available when the operation is stopped)
- If you enter the option setting, display will show the following.
- Seg1 and Seg2 will display the number for selected option.
- Seg3 and Seg4 will display the number for set value of the selected option.
2. If you have entered option setting, you can shortly press the K1 switch to adjust the value of the Seg1, Seg2 and select
the desired option.
Example)
3. If you have selected desired option, you can shortly press the K2 switch to adjust the value of the Seg3, Seg4 and change
the function for the selected option.
Example)
4. After selecting the function for options, press and hold the K2 switch for 2 seconds. Edited value of the option will be
saved when entire segments blinks and tracking mode begins.
• Edited option will not be saved if you do not end the option setting as explained in above instruction.
CAUTION
❋ While you are setting the option, you may press and hold the K1 button to reset the value to previous setting.
❋ If you want to restore the setting to factory default, press and hold the K4 button while you are in the option setting
mode.
- If you press and hold the K4 button, setting will be restored to factory default but it doesn't mean that restored setting
is saved. Press and hold the K2 button. When the segments shows that tracking mode is in progress, setting will be
saved.
Optional item SEG1
0
Channel address
0
0
Base Heater
0
SEG2 SEG3 SEG4
0 A U
0 0~15
1 0 0
1 0 1
ENGLISH-39
Function of the option
Automatic setting(Factory
default)
Manual adressing
Use(Factory default)
Not use
Remarks
Address for classifying the product
from upper level 0 ~ 15 controller
(DMS, S-NET 3, etc)
-
-