Table of Contents
Advertisement
3.1.2 Removing the side panels (L)/(R)
(See Fig.3)
• Remove the rear cover.
(1) From the bottom side of the main body, remove the two
screws C attaching the side panels (L)/(R).
(2) Slide the side panels (L)/(R) in the direction of the arrow
and remove the side panels (L)/(R).
3.1.3 Removing the top cover assembly
(See Figs.4 and 5)
• Remove the rear cover and side panels(L)/(R).
(1) From the left side of the main body, disconnect the card
wires from the connectors (CN703, CN709) on the micon
board. (See Fig.4.)
(2) Remove the screw D attaching the top cover assembly.
(See Fig.4.)
(3) From the right side of the main body, disconnect the card
wire from the connector
Fig.5.)
(4) Disconnect the wire from the connector
board. (See Fig.5.)
Reference:
When connecting the wire, pass it through the slot b of
the main board as before. (See Fig.5.)
(5) From the both sides of the main body, remove the two
screws E and screw F attaching the top cover assembly.
(See Figs.4 and 5.)
(6) Release the joints a and remove the top cover assembly.
(See Figs.4 and 5.)
1-8 (No.MB338)
CN105
on the main board. (See
CN108
on the main
C
Side panel(R)
C
Side panel(R)
Fig.3
D
Top cover assembly
CN703 CN709
Fig.4
Top cover assembly
E
a
CN108 CN105
Main board
Fig.5
E
a
Micon board
F
b
Advertisement
Chapters
Table of Contents
