Table of Contents
Advertisement
3.2.8 Attaching the pickup
(See Figs.7, 9 to 12)
• See "3.2.7 Removing the pickup".
(1) Attach the shaft, SW actuator and LEAD spring to the pick-
up. (See Fig.11.)
(2) Align the pickup to the section m of the traverse mecha-
nism assembly first, and set the both ends of the shaft of
the pickup in the sections (j, k) of the traverse mechanism
assembly. (See Fig.10.)
(3) Attach the plate and thrust spring. (See Fig.9.)
(4) Remove the solders from the soldered sections e after at-
taching the card wire to the connector on the pickup. (See
Figs.7 and 9.)
(5) Turn the feed gear M in the direction of the arrow 1 to move
the pickup fully in the direction of the arrow 2. (See Fig.12.)
Feed gear M
1
2
Pickup
Fig.12
(No.MB338)1-21
Advertisement
Chapters
Table of Contents
