JVC UX-QD9S Service Manual page 17

3.2 DVD mechanism assembly section
• Remove the DVD mechanism assembly from the main body.
(See "3.1.16 Removing the DVD mechanism assembly".)
3.2.1 Removing the DVD cover
(See Fig.1)
(1) From the top side of the DVD mechanism assembly, re-
move the two screws A attaching the DVD cover.
(2) Remove the double-stick tape fixing the card wire.
(3) Lift the DVD cover in an upward direction and remove it
from the projections a of the DVD mechanism assembly.
(4) Slide the DVD cover in the direction of the arrow and re-
move it from the sections b.
(5) Release the lock of the connector
and disconnect the card wire.
3.2.2 Removing the joint board
(See Fig.2)
• Remove the DVD cover.
(1) From the inside of the DVD cover, remove the screw B at-
taching the joint board.
(2) Remove the spacer attaching the joint board and take out
the joint board from the DVD cover.
CN4 on the LED board
Double-stick tape
Card wire
A
a
a
A
Clamper base
DVD mechanism assembly
Fig.1
Clamper base
B
Joint board
Fig.2
CN4
Card wire
LED board
b
b
Spacer
(No.MB338)1-17