Table of Contents
Advertisement
3.2.11 Removing the DVD loading switch board
(See Fig.17)
(1) From the bottom side of the DVD mechanism assembly, re-
move the screw M attaching the DVD loading switch board.
(2) Remove the wires from the soldered sections r on the DVD
loading switch board.
(3) Lift the DVD loading switch board while pressing the claw
s of the DVD mechanism assembly in the direction of the
arrow and remove the DVD loading switch board from the
section t.
(4) From the forward side of the DVD loading switch board,
disconnect the card wire from the connector CN1.
Reference:
• Put the wires on the section u after attaching the DVD load-
ing switch board to the DVD mechanism assembly.
• Fix the claw t on the DVD mechanism assembly with bonds
after attaching the DVD loading switch board.
3.2.12 Removing the motor
(See Figs.17 and 18)
• Remove the DVD cover and tray assembly.
(1) From the bottom side of the DVD mechanism assembly, re-
move the wires from the soldered sections r on the DVD
loading switch board. (See Fig.17.)
(2) From the top side of the DVD mechanism assembly, re-
move the belt from the motor pulley. (See Fig.18.)
Note:
Take care not to attach grease on the belt.
(3) Remove the two screws N attaching the motor to the DVD
mechanism assembly and take out the motor from the bot-
tom side of the DVD mechanism assembly. (See Fig.18.)
DVD loading switch board
Wires
r
CN1
t
u
M
DVD mechanism assembly
Fig.17
DVD mechanism
assembly
N
Fig.18
s
Motor
Belt
Motor pulley
(No.MB338)1-23
Advertisement
Chapters
Table of Contents
