Description Of The Xcommands Commands - Cisco TelePresence ISDN Link Reference Manual

Cisco TelePresence ISDN Link
Contents Introduction

Description of the xCommands commands

In the following pages you will find a complete list of all xCommand type commands with
parameters. We recommend you visit our web site regularly for updated versions of the manual.
Go to: http://www.cisco.com/go/isdnlink-docs
The Boot commands
xCommand Boot
Reboot system.
USER
Requires user role:
Example:
xCommand Boot
*r BootResult (status=OK):
** end
OK
CUIL reboot request, restarting
Connection closed by foreign host.
D14953.01 ISDN Link API Reference Guide IL1.0 June 2012.
© 2012 Cisco Systems, Inc. All rights reserved.
About the API xConfiguration
The Security commands
xCommand Security FIPSMode Activate
38
xCommand xCommand
Activate FIPS (140-2) mode. NOTE: Activating FIPS mode implies a reset to factory defaults.
While in FIPS mode, software upgrade is disabled and the following limitations will apply: All calls will
be encrypted. IEEE802.1x and SNMP are disabled. The SIP Profile Type setting cannot be Microsoft.
The root user is not available (root settings cannot be changed). To exit FIPS mode, perform a
factory reset.
Confirm: <Yes>
ADMIN
Requires user role:
Parameters:
Confirm(r): <Yes>
Example:
xCommand Security FIPSMode Activate Confirm: "Yes"
OK
*r SecurityFIPSModeActivateResult (status=OK)
** end
API Reference Guide
xStatus Contact us
www.cisco.com