b
Use a 1/2" open end wrench
to unscrew both orifices.
Rear Burner
1/2" Wrench
Orifice
Front Burner
Orifice
Manifold
Lift the pilot hood
a
off the pilot
assembly.
Front Orifice
c
Apply thread sealant to the LP
orifices prior to installation. Use
the chart below to identify the
correct orifices.
Look here for the orifice identification
LP
Front
#55
Rear
#55
Remove the orifice and replace with the LP orifice. Screw the
c
orifice all the way in and replace the pilot hood.
Use a hex wrench to
b
unscrew the orifice.
5/32" Hex
NOTE: when re-attaching,
this pin lines up with the
notch in the pilot hood.
Slide the air shutters all
a
the way to the left.
Screw the LP orifice in so the
orifice shoulder protrudes 5/16"
(indicating full insertion).
5/16"
NG
#46
#44
Rear Orifice
Manifold
d
Orifice Identification:
LP (Propane) Orifice
35
35
NG (Natural Gas) Orifice
62