Specifications; Radio Signal - Inspire Ignite Wireless Installation Manual

Specifications

Relay Module
Power Supply: 230V~ 50...60Hz, 2.5W (Max)
Switch Type: 2 x SPDT
Switch Rating: 3 Amps Total load on all Channels
Radio Frequency: 2.4 GHz WiFi & 868 MHz
Dimensions: 160 x 100 x 18 mm (35mm including recessed wallmount)
Thermostat
Power Supply: 2 x AA Alkaline Batteries
Controllable Temperature Range: 10 – 30°C
Frost Protection: Programmable from 0.5 ­ 30°C
Radio Frequency: 868 MHz
Dimensions: 103 x 103 x 45 mm (max)

Radio Signal

Consideration for location of your new system components and the affects that this may
have on the radio signal is extremely important. The signal will travel between units in a
straight line and will degrade both with distance and (much more importantly) objects that it
has to pass through.
The Relay Module uses WiFi, so you need a WiFi signal where the Relay Module is located.
You can use your phone to get a good indication of signal strength, hold this against the wall
where the Relay Module is located.
If you cannot get a good signal, consider using a Wifi Range extender to help boost the
signal around the property.
The Thermostat needs to connect to the Relay Module via its internal low power radio.
Every house is different and this is NOT a gaurantee, but as a guide, the units should be
able to communicate with each other through two single skin brick or stud walls.
If the above is not possible then consider moving one or more of the system components.
Also, the radio can be adversely affected by large metal objects such as your boiler, hot
water cylinder, radiators and mirrors. For best performance, ensure that your units are
placed at least 1 metre away from such objects.
2