Download Print this page

Inspire Ignite Manual

Smart sensor

Hide thumbs Also See for Ignite:

WHAT'S IN THE BOX

1 x Ignite Smart

2 x AAA

1 x Screw

Sernsor

Batteries

Pack

TOOLS REQUIRED

Ignite Smart Sensor

Drill + 5mm

Phillips

rev 1.1

Drill Bit

Screwdriver

www.inspirehomeautomation.co.uk

Table of Contents

Need help?

Do you have a question about the Ignite and is the answer not in the manual?

Page 1 WHAT'S IN THE BOX 1 x Ignite Smart 2 x AAA 1 x Screw Sernsor Batteries Pack TOOLS REQUIRED Ignite Smart Sensor Drill + 5mm Phillips rev 1.1 Drill Bit Screwdriver www.inspirehomeautomation.co.uk...
Page 2: Radio Signal
The Smart Sensor should not be installed in areas subject to extended periods of high humidity, e.g. bathrooms The Smart Sensor needs to connect to the Receiver (Ignite Wireless / LITE) or Thermostat (Ignite Wired) via its internal SPECIFICATIONS low power radio.
Page 3: Battery Installation
BATTERY INSTALLATION We recommend that you pair the Smart Sensor with your Ignite System prior to fixing it to the wall. 1. Whilst holding the back plate, rotate the outer cover anticlockwise and remove in direction shown below Fig 1 Fig 2 shows another two possible positions.
Page 4: Pairing Instructions
PAIRING INSTRUCTIONS Smart Sensor Ensuring the Inspire leaf logo is at the top, press and hold \/ button for 5 seconds. All 5 LED's will slowly flash to indicate Put the Ignite device into pairing mode as detailed below unit is in pairing mode.
Page 5: Installation Instruction
If you are adding multiple Smart Sensors, you can RENAME them via your online account. Please login and click the unit setup to begin. We would recommend naming them as you pair them to the Ignite system. Fig 6 9. Secure outer cover by following Step 1 in reverse...