Advertisement
6. INSTALL BASE PLATE ASSEMBLY:
Install base plate assembly onto inside of door. (If the door is less than 1-3/4" thick, install spacer between the base plate
and the door.) Use socket cap screws with washers on upper standoffs and phillips head screws on lower (retractor assem-
bly) standoffs.
Make sure standoffs
insert into these holes
Form 51005 Rev. D
CM5100 COMPUTER MANAGED CYLINDRICAL LOCK
before tightening.
SPACER
(
FOR DOORS LESS THAN
If any fasteners such, as washers, fall
behind the PC board, remove them prior to
6
INSTALLATION MANUAL
1-3/4")
CAUTION!
installing batteries.
SOCKET CAP
,
SCREW
WASHERS
PHILLIPS HEAD
SCREWS
12-02-2002
Advertisement
