Siemens Gigaset S790 Manual page 65

Gigaset S790/S795 / USA-CAN EN / A31008-M2121-R301-1-3S19 / appendix.fm / 28.07.2009
During the transfer of data between hand-
set and PC, you will see Data transferin
progress on the display. During this time
the keypad is disabled, and incoming calls
will be ignored.
Completing a firmware update
¤
Connect you phone to your PC using a
USB data cable (
¤
Start the "Gigaset QuickSync" program
on your PC.
¤
Establish a connection to your handset.
¤
Select [Settings]
ties]to open the [Device properties]
tab.
¤
Click on [Firmware update].
This launches the firmware update.
The update process can take up to 10 min-
utes (not including the download time).
Do not interrupt the process or remove
the USB data cable.
The data is initially loaded from the
update server on the Internet. The
amount of time required depends on the
speed of your Internet connection.
The display on your phone is switched off
and the message key f and the talk key
c start flashing.
When the update is complete, your phone
will automatically restart.
Procedure in case of an error
If the update procedure fails or your
phone does not work properly following
the update, repeat the update procedure
as follows:
¤
Close the "Gigaset QuickSync" pro-
gram on the PC.
¤
Remove the USB data cable from the
telephone.
¤
Remove the battery (
¤
Replace the battery.
¤
Complete the firmware update as
described.
¢
page 18).
¢
[Device proper-
¢
page 12).
Additional functions via the PC interface
If the update procedure fails several times
or you can no longer connect to the PC,
proceed as follows:
¤
Close the "Gigaset QuickSync" pro-
gram on the PC.
¤
Remove the USB data cable from the
telephone.
¤
Remove the battery (
¤
Press and hold keys 4 and L with
the index and middle finger.
¤
Replace the battery.
¤
Release keys 4 and L. The mes-
sage key f and the talk key c will
flash alternately.
¤
Complete the firmware update as
described.
¢
page 12).
65