Led/Io6 Capabilities; Adin4; Digital To Analogue Converter - Dac [Not Implemented Yet] - Wavecom GR64 GSM/GPRS Integrator's Manual

5.16.2 LED/IO6 Capabilities

The LED function pin can be used as a general purpose digital I/O when the flashing
LED function is not required. However, this pin does not have an on-board pull-up
resistor. It is required that an external pull-up or pull-down resistor be provided by
the host circuitry when either not used or when used as a digital input.

5.16.3 ADIN4

A further ADC input (in addition to the three dedicated pins) is created by
multiplexing one of the GPIO signals (GPIO5). ADIN4 has a 6dB attenuator built-in to
the Wireless CPU so that it can accommodate an input voltage up to 5.0V.
5.17 Digital to Analogue Converter – DAC [not implemented yet]
Pin
20
The GPIO15 has dual functionality. In addition of being a fully programmable GPIO it
also has the capability of becoming a PWM output. This PWM can be used as a DAC
by implementing an RC-filter followed by an optional buffer.
Figure 26: Typical arrangement for adapting PWM for a DAC function
GR64 Integrators Manual
Page: 73/104
Name Direction
DAC Output
This document is the sole and exclusive property of WAVECOM. Not to be distributed or divulged without prior written agreement.
Ce document est la propriété exclusive de WAVECOM. Il ne peut être communiqué ou divulgué à des tiers sans son autorisation préalable
Function
Pulse width modulated signal