Controls And Indicators; Pre-Operation Safety Inspection - Snorkel TM12 Service And Parts Manual

Controls and Indicators

C
ONTROLS AND
The operator shall know the location of each control and indicator and have a thorough knowledge of the
function and operation of each before attempting to operate the unit.
3
4
9
W
ARNING
The warning beacon is located beneath the upper control panel.
The beacon flashes when the machine is switched on and capable
of powered motion.
P -O
RE
NOTE: Carefully read, understand and follow all safety rules, operating instructions, labels and National Safety
Instructions/Requirements. Perform the following steps each day before use.
1. Open the Chassis Door and inspect for damage, fluid leaks or missing parts.
2. Check the level of the hydraulic fluid with the platform fully lowered. Open the Chassis Door and remove
the reservoir cap, fluid should be visible on the dipstick. Add recommended hydraulic fluid if necessary.
See "Specifications" on page 14.
3. Check that the fluid level in the batteries is correct. See "Battery Maintenance" on page 11.
4. Verify that the batteries are charged.
5. Check that the A.C. extension cord has been disconnected from the chassis outlet.
6. Check that all guardrails are in place and all fasteners are properly tightened.
7. Inspect the machine thoroughly for cracked welds and structural damage, loose or missing hardware,
hydraulic leaks, damaged control cable and loose wire connections.
Page 5
I
NDICATORS
Platform Controller
2
1
Side View
1. Joystick
2. Emergency Stop
3. Lift Button
4. Drive Button
5. Emergency Stop (chassis)
B
EACON
S
PERATION AFETY
5
10
Top View
6. Toggle switch (chassis)
7. Enable button
8. Keyswitch
9. Horn Button
10. Display
I
NSPECTION
Figure 2: Controls and Indicators
Chassis Controller (Right Side)
6
Figure 2A: Flashing Warning Beacon
Operation Manual
7
8