Hoffer Flow Controls HIT-2A User Manual page 38

READ Example:
If the sending unit wishes to read the number of points that the
HIT-2A has in the K factor table, the sending unit shall send
The HIT-2A echoes the sent message, and responds with
WRITE Example:
If the sending unit wishes to change the number of points to 20 in
the K factor table, the sending unit shall send
The HIT-2A echoes the sent message and responds with
The HIT-2A checks the ranges for data and rejects writes that are not
within the allowed range. If the sending unit sends data that is not
within the allowed range, the HIT-2A echoes the sent message and
responds with the value that is currently stored in the HIT-2A.
Example:
If the sending unit wishes to change the max sample time to 2000
from the previous setting of 10, the sending unit shall send
The HIT-2A echoes the sent message, and responds with
HP-306
Appendix B
"NP<CR>"
"NUM PTS
"NP=20<CR>"
"NUM PTS
"NB=2000<CR>"
"MAX M TIME=
- Communications
= 2<CR>"
= 20<CR>".
10<CR>".
30