Table of Contents
Advertisement
3.2
Connect AC power
Important! Always press & hold
power plug.
Ensure that all rear connections are established before you power up the set.
Connect the AC power cord to the mains outlet.The set is now powered up (switched on).
When in Standby or Eco Standby mode,
To disconnect the system from the power supply completely, remove the power plug from the
mains outlet.
For users in the U.K., please follow the instructions on page iii.
3.3
Set up Wi-Fi connection between Center (
Note
• Always press & hold
power plug.
• Always power up the
• Never block
• Avoid installation near large metal objects.
The Wi-Fi connection starts automatically when you power up both
The first time you set up a Wi-Fi connection place
surface.
1 Using the supplied power cables, connect first
>
and
are ready for use.
Tip
For better Wi-Fi reception, rotate the Wi-Fi antenna or adjust the location of
3.4
Rear connections
Note
• Never connect or disconnect power cables when the mains supply is switched on.
• Install
and
22
y
to switch the set to power-saving mode before removing its
y
to switch the set to Eco standby (power-saving mode) before removing its
first, and then power up the
from
by thick walls or more than one wall.
within easy reach of suitable AC power outlets.
and
still consume some power.
) and Station (
.
and
side by side on a level and sturdy
and then
)
and
.
to the power supply.
and
.
Installation
Advertisement
Table of Contents
