Prepare; Install Remote Control Batteries; Position Your Mci300; Connect Ac Power - Philips MCI300/05 User Manual

3 Prepare

Install remote control
batteries
Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine or fire. Never discard batteries in fire.
•
Risk of decreased battery life! Never mix different
brands or types of batteries.
•
Risk of product damage! When the remote control is
not used for long periods, remove the batteries.
1
Open the battery compartment.
2
Insert 2 AAA batteries with correct
polarity (+/-) as indicated.
3
Close the battery compartment.

Position your MCi300

Caution
•
Risk of product damage! Place the MCi300 on a surface
that is level, flat, and strong enough to support the
MCi300.

Connect AC power

Warning
•
Risk of product damage! Ensure that the power supply
voltage corresponds to the voltage printed on the back
or the underside of the MCi300.
1
Connect the MCi300 to the power supply
Your MCi300 turns on and is ready to
»
be set up for use.
Note
•
The type plate information is located at the back or at
the underside of the MCi300.

Turn on / switch to standby

You can select from the following status options:
• On
• Standby
• Active standby. The
the remote control can turn on the
MCi300.
• Eco standby
• Passive standby. Only the
on the top panel can turn on the
MCi300.
Note
•
If no buttons are pressed for 20 minutes, the MCi300
switches to standby.
1
To turn on the MCi300, press .
2
To switch the MCi300 to standby, press .
3
To switch the MCi300 to eco standby,
press and hold the button on the top
panel.
button on
button
EN
9