Table of Contents
Advertisement
Problem
Nothing appears on the synchronous
display of the 2-way remote control
of
even after the set is switched
on.
The remote control does not
function properly.
The screen of
or shows no response for a long
period of time (2-5 minutes).
'No Disc' / 'Cannot read CD' is
displayed.
Sound cannot be heard or is of poor
quality.
The disc skips tracks.
Sound skips during MP3/WMA
playback.
Frequently asked questions
Solution
You have switched on the set with the
the set and not the
control. Press
control to synchronize its display.
• Reduce the distance between the remote control
• Insert the batteries with correct polarity (+/- as
• Replace the batteries.
• Point the remote control directly towards the IR
is stuck in a menu
Please first try to press
If the problem persists, restart the power (disconnect
and reconnect the mains plug) to reset
• Insert a suitable disc.
• Check if the disc is inserted with the graphics side
• Wait for the moisture condensation on the lens to
• Replace or clean the disc, see 1.5 Maintenance.
• Use a finalized CD-RW or CD-R.
• Adjust the volume.
• Disconnect the headphones.
• Switch off MUTE.
• Replace or clean disc.
• Switch off SHUFFLE.
• The MP3/WMA file may be made at a compression
• Replace or clean disc.
y
button on the 2-way remote
REFRESH
and the set.
indicated inside the compartment).
sensor.
(label) facing you.
clear.
level exceeding 320kbps. Use a lower compression
level to rip audio CD tracks.
y
button on
on center's 2-way remote
y
to go to power-saving mode.
.
91
Advertisement
Table of Contents
