Network - TP-Link TL-WA701ND User Manual

Note:
The default PIN code of the AP can be found in its label or the QSS configuration screen as Figure
3-4.
You will see the following screen when the new device has successfully connected to the network.
Note:
a. The QSS LED on the AP will light green for five minutes if the device has been successfully
added to the network.
b. The QSS function cannot be configured if the Wireless function of the AP is disabled. Please
make sure the Wireless function is enabled before configuring the QSS.

3.4 Network

You can configure the IP parameters of Network on this page.
Type - Choosing Dynamic IP (DHCP) to get IP address from DHCP server, or choosing Static
IP to configure IP address manually.
IP Address - Enter the IP address of your AP in dotted-decimal notation (factory default:
192.168.1.254).
Subnet Mask - An address code that determines the size of the network. Normally use
255.255.255.0 as the subnet mask.
TL-WA701ND 150Mbps Wireless Lite N Access Point User Guide
Figure 3-6 Network
18