Set-Up Adjustments; Focus Rough Adjustment; Deflection Yoke Tilt Adjustment; Screen Voltage Adjustment (Rough Alignment) - Sony KP-FX432M31 Service Manual

Ax-1 chassis, crt projection tv
Hide thumbs Also See for KP-FX432M31:
Table of Contents

Advertisement

3-1. SCREEN VOLTAGE ADJUSTMENT
(ROUGH ALIGNMENT)
1. Receive the Monoscope signal.
2. Set 50% BRIGHTNESS and minimum PICTURE.
3. Turn the red VR on the focus pack all the way to the left and
then gradually turn it to the right until the point where you can
see the retrace line.
4. Next gradually turn it to the left to the position where the
retrace line disappears.
Focus Pack
B
B
Fig. 3-1
3-2. SCREEN (G2) ADJUSTMENT
(FINE ADJUSTMENT)
1. Turn on the power of the set.
2. Select VIDEO1 and make no signal input.
3. Supply DC (177.5 ± 0.5V) from external power supply to KR.
(Fig.3-2)
3. Turn red of G2 VR clockwise, then retrace line appear.
4. Turn G2 VR counterclockwise and set retrace line just
disappear.(Fig.3-3)
5. Add DC voltage DC (174 ± 0.5V) to KR.
6. Confirm if retrace can be seen.
7. Adjust green and blue at the same method.
Power
Supply
Fig. 3-2
Test signal
Fig. 3-3
SECTION 3

SET-UP ADJUSTMENTS

FOCUS
G
R
SCREEN
G
R
+
Dummy Resister
3k ohm 20W
KP-FX432M31/FX432M91/FX532M91

3-3. FOCUS ROUGH ADJUSTMENT

1. Connect VIDEO-1 terminal.
2. Receive video dot hatch pattern.
3. Use lens-cover to red and blue.
4. Adjust electric focus. (roughly)
5. Rotate the green lens and adjust to obtain the best lens focus.
6. Rotate the green focus volume on the focus pack and adjust to
obtain best electrical focus.
7. If focus is not good, repeat 4 process.
8. Repeat above process for red and blue lenses and electric fo-
cus.
9. Fix lens screw.
Lens
Fig. 3-4

3-4. DEFLECTION YOKE TILT ADJUSTMENT

1. Receive the Monoscope signal.
2. Place the caps on the red and blue lens so that only the green
color.
3. Loosen the deflection yoke setscrew and align the tilt of the
Deflection yoke so that the bars at the center of the
monoscope pattern are horizontal.
4. After aligning the deflection yoke, fasten it securely to the
funnel-shaped portion of the CRT.
5. The tilt of the deflection yoke for red and blue is aligned the
same as was done for green.
2-pole magnet
VMcoil Assy
Make sure deflection yoke is
touching CRT closely.
– 17 –
RM-998
RM-998
Scanning line visible.
A
Minimize both A and B.
B
Fig. 3-5
4-pole magnet
Deflection yoke
Anode cap
Centering magnet
Fig. 3-6
RM-998

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kp-fx532m91Kp-fx432m91

Table of Contents