1-6. SELF-DIAGNOSTIC CIRCUIT
87 LOW B ERR
AC RLY 36
33 HV PROT
+B overcurrent (OCP)
+B overvoltage (OVP)
White balance failure
Low +B OCP/OVP
Horizontal deflection stopped
V PROT 56
HG PROT 57
Occurs when excessive current flows through R6812.
The increase in voltage across Q6803 causes it to turn on which sends a high
signal to the micro.
IC6801 detects +B OVP condition and Q6802.
This sends a high signal to the micro and also shuts down the AC relay.
Occurs when an absence of the vertical deflection pulse is detected by pin 56 of
IC0404 (MG board)
Power supply will shut down when waveform interval exceeds 2 seconds.
If the RGB levels* do not balance within 2 seconds after the power is turned on,
this error will be detected by IC0401.
TV will stay on, but there will be no picture.
Occurs when set 5V is out.
Occurs when either :
1) a +B overcurrent is detected (Q6803), or
2) IC0401 (MG board) is damaged.
– 8 –
< +B OCP >
< H PLS