3-10. REGISTRATION ADJUSTMENT
3-10-1. Adjustment Flow
START
Turn on the power and wait for 10 minutes
Set to the PAL Full mode
Check the deflection yokes, the centering magnets, 2 pole/4 pole magnets
Set to the service mode
MAIN DEFLECTION ADJUSTMENT ( Green)
→
Green coarse adjustment
Green fine adjustment
Red coarse adjustment
SUB DEFLECTION
Change the
ADJUSTMENT
Red fine adjustment
display mode
Blue coarse adjustment
Blue fine adjustment
YES
Another display mode ?
ALLCOPY
NO
Memorize the FLASH FOCUS offset data
50 Hz and 60 Hz
End
KP-FX432M31/FX432M91/FX532M91
RM-998
RM-998
RM-998
3-10-2. Setup for Adjustment
1. Marking
1) At the 4 insides of the screen, locate the middle. Use a tape
measure to identify the middle.
x
×
x
x
: middle
x
3-10-3. Method of Main Deflection Adjustment
1. Place the caps on the red and blue lenses so that only the green
color is displayed.
2. Enter the PAL SPCB signal, and set the DRC1250.
3. Set in the Service mode, and select the category “DEF1” ,
“DEF2”.
4. Adjust “00 VPOS” in “DEF1” so that the picture is displayed
in the center of screen.
00 VPOS
5. Adjust “01 VSIZ” in “DEF” and “02 HSIZ” “DEF2” so that
the picture size is within the specification.
01 VSIZ
02 HSIZ
SPECIFICATION :
Overscan Spec. = 0.9%
Input Signal
H SIZE
V SIZE
16.4 ± 0.1 sq.
12.3 ± 0.1 sq.
PAL SPCB
Page 67