GE T35 Instruction Manual page 18

1.3 ENERVISTA UR SETUP SOFTWARE
10. Click OK when the relay order code has been received. The new device will be added to the Site List window (or
1
Online window) located in the top left corner of the main EnerVista UR Setup window.
The Site Device has now been configured for Ethernet communications. Proceed to Section c) below to begin communica-
tions.
b) CONFIGURING AN RS232 CONNECTION
Before starting, verify that the RS232 serial cable is properly connected to the RS232 port on the front panel of the relay.
1. Install and start the latest version of the EnerVista UR Setup software (available from the GE enerVista CD or online
from http://www.GEindustrial.com/multilin.
2. Select the Device Setup button to open the Device Setup window and click the Add Site button to define a new site.
3. Enter the desired site name in the "Site Name" field. If desired, a short description of site can also be entered along
with the display order of devices defined for the site. Click the OK button when complete.
4. The new site will appear in the upper-left list in the EnerVista UR Setup window. Click on the new site name and then
click the Device Setup button to re-open the Device Setup window.
5. Click the Add Device button to define the new device.
6. Enter the desired name in the "Device Name" field and a description (optional) of the site.
7. Select "Serial" from the Interface drop-down list. This will display a number of interface parameters that must be
entered for proper serial communications.
• Enter the relay slave address and COM port values (from the
!"
SERIAL PORTS
• Enter the physical communications parameters (baud rate and parity settings) in their respective fields.
8. Click the Read Order Code button to connect to the T35 device and upload the order code. If an communications error
occurs, ensure that the EnerVista UR Setup serial communications values entered in the previous step correspond to
the relay setting values.
9. Click "OK" when the relay order code has been received. The new device will be added to the Site List window (or
Online window) located in the top left corner of the main EnerVista UR Setup window.
The Site Device has now been configured for RS232 communications. Proceed to Section c) Connecting to the Relay
below to begin communications.
c) CONNECTING TO THE RELAY
1. Open the Display Properties window through the Site List tree as shown below:
1-8
menu) in the "Slave Address" and "COM Port" fields.
T35 Transformer Management Relay
1 GETTING STARTED
!
SETTINGS PRODUCT SETUP
!"
COMMUNICATIONS
GE Multilin