Antenna Board - HP Elite x3 Maintenance And Service Manual

Antenna board

Description
Antenna board
Before removing the antenna board, follow these steps:
1. Disconnect the power from the device by unplugging the power cord from the device.
2. Turn off the device. If you are unsure whether the device is off, turn the computer on, and then shut it
down through the operating system.
3. Disconnect all external devices from the device.
4. Remove the card reader tray (see
5. Remove the end cap (see
6. Remove the display panel assembly (see
7. Remove the chassis (see
8. Remove the rear camera (see
9. Remove the system board (see
IMPORTANT:
Remove the antenna board:
1. Remove the two M1.1_L2.1 Phillips screws (1) securing the antenna board.
2. Lift and remove the antenna board (2).
Reverse this procedure to install the antenna board.
36 Chapter 5 Removal and replacement procedures
Card reader tray on page
End cap on page
Chassis and battery removal on page
Rear camera on page
System board on page
Make careful note of the routing of antenna cable for later replacement.
17).
18).
Display panel assembly on page
27).
30).
32).
Spare part number
903688-001
19).