Table of Contents
Advertisement
4.
Disconnect the main antenna cable (4) from the system board.
NOTE:
Note the routing of the cable.
5.
Remove the four T5 screws (1) securing the system board.
6.
Lift the system board from the back cover.
NOTE:
The fingerprint reader/NFC sensor flex cable is connected under the system board. It is next to
the power button, and is routed under the antenna wire.
7.
Release the fingerprint reader/NFC module flex cable from the ZIF connector, and then remove the
system board (2).
Reverse this procedure to install the system board.
System board
33
Hide quick links:
Advertisement
Table of Contents
