Iris Camera - HP Elite x3 Maintenance And Service Manual

Iris camera

Description
Iris camera, 2.4 MP (includes cable)
Before removing the iris camera, follow these steps:
1. Disconnect the power from the device by unplugging the power cord from the device.
2. Turn off the device. If you are unsure whether the device is off, turn the computer on, and then shut it
down through the operating system.
3. Disconnect all external devices from the device.
4. Remove the card reader tray (see
5. Remove the end cap (see
6. Remove the display panel assembly (see
7. Remove the chassis (see
8. Remove the rear camera (see
9. Remove the system board (see
Remove the iris camera:
▲ Lift and remove the iris camera.
NOTE:
Reverse this procedure to install the iris camera.
End cap on page
Chassis and battery removal on page
Rear camera on page
System board on page
There is adhesive securing the camera to the back cover.
Card reader tray on page
18).
Display panel assembly on page
30).
32).
Spare part number
900262-001
17).
19).
27).
Iris camera 35