Table of Contents
Advertisement
14.
Use a spudger to disconnect the 60 pin display flex connector (7).
15.
Use a spudger and 70 percent isopropyl alcohol to remove any remaining glue from the display and main
assembly.
Use the following procedures to replace the display panel assembly.
IMPORTANT:
instructions for your specific glue machine to apply the glue to the device, and then replace the display panel
assembly.
1.
Set up the glue machine.
a.
Program the glue machine to dispense glue to match the Glue Path Golden Sample provided by
your HP service contact.
b.
Make sure the glue tube is installed per the manufacturer's instructions.
NOTE:
following criteria:
●
●
●
c.
Test the glue path with at least four samples. Be sure to clean the glue nozzle after each sample.
NOTE:
2.
Apply the display pressure-sensitive adhesive.
IMPORTANT:
device is completely clean. Remove any dust with compressed air or with a lint- and static-free cloth and
alcohol.
22
Chapter 5 Removal and replacement procedures
The following instructions are general guide to replace the display panel assembly. Follow the
As many as 10 samples of the glue path could be required. Each sample must fit the
Have a clear, protective film for the glue that can be discarded without ruining the device
Visually match the Glue Path Golden Sample
Have a glue weight of no less than 0.23 g and no more than 0.28 g
Calibrate the glue machine every 80 to 100 runs.
Before applying the display pressure-sensitive adhesive, be sure the chassis side of the
Hide quick links:
Advertisement
Table of Contents
