Table of Contents
Advertisement
c.
Allow glue to dry at least 4 hours in an environment of 75%–85% humidity and 25.0° C (77.0° F).
d.
Remove the screws in the order shown.
e.
Remove the device from the display pressing fixture.
f.
Remove the 7 pieces of tape.
7.
Clean the glue
a.
Visually inspect the glue locations along all of the edges.
NOTE:
b.
Use a plastic spudger to remove any excess glue.
c.
Visually inspect the glue locations along all of the edges again.
d.
Use a lint- and static-free cloth with 70 percent isopropyl alcohol to remove any excess glue.
e.
Visually inspect the glue locations along all of the edges again.
f.
Repeat steps b. – e. as needed.
g.
Replace the end cap, card reader tray, and any external devices.
26
Chapter 5 Removal and replacement procedures
Most glue will be found along the top edge.
Hide quick links:
Advertisement
Table of Contents
