Adjustment Locations Of Hp 54501A Crt - HP 54501A Service Manual
100 mhz digitizing oscilloscope
Hide thumbs
Also See for 54501A:
- Programming reference manual (386 pages) ,
- Operation reference (146 pages) ,
- Service manual (90 pages)
Table of Contents
Advertisement
HP 54501A ADJUSTMENTS
CON
HEIGHT
V.LIN
\
V.HOLD-
H .PHASE
Figure 4-3. Adjustment Locations of HP 54501A CRT Monitor Assembly
4-7. Intensity, Sub-bright, and Contrast Adjustment
1 .
Set rear-panel INTENSITY to the mid-range setting .
2.
Adjust sweep board SUB-BRIGHT control to the lowest setting of brightness where lower-
intensity blocks on menu are visible on the CRT screen .
3 .
Turn rear-panel INTENSITY to bring up the intensity level on screen . Screen intensity should
be at a comfortable viewing level and the position of adjustment should be close to three-
quarter range .
4 .
Adjust CONT for the best contrast between low- and high-intensity blocks on menu ensuring
text is legible in low-intensity blocks.
Advertisement
Table of Contents
