Sensor Base Wiring - Cooper CF2000 Installation Manual

SensorBase Wiring CAB300
Supply Voltage
Cable Size
Recommended cable types
Mounting Hole Centres
Wiring Hints
! Each terminal is suitable for clamping up to 2 wires
! Clamping of 2 wires of very different diameters under one screw is not
recommended.
! Suitable for mounting to mounting boxes with 50-80mm fixing centres.
General
If difficulty is experienced when mounting the sensor, this may be due to the following:
! Wiring causing an obstruction - move or shorten wires.
! Although the base is tolerant to uneven mounting surfaces, a very uneven
surface may cause the base to deform when the mounting screws are tightened
down - loosen screws to reduce this or slide base to a flat position.
WARNING: DO NOT USE HIGH VOLTAGE TESTERS WHEN SENSORS OR
CONTROL PANEL ARE CONNECTED TO THE SYSTEM.
S+
_
S
_
_
_
_
F
F+
_
_
_
18 - 30 V DC
0.5 - 2.5mm²
FIRETUF,FP200 or MICC
50 - 80mm
+
+VIN
- VE COM IN
Earth screen of cable to be continuous between sensors
79
Remote
Indicator
LED
(optional)
- VE COM OUT