Safety Informations - Ganz ZN-L7210PHA Instruction Manual

SAFETY INFORMATIONS

Electrical shock hazard
Never attempt to connect the unit or the mains power supply to any power network
other than the one for which it was
Use only appropriate and approved power supply units for the camera (see
technical specifications)
Do not open the housing of the power supply unit
Disconnect the power supply unit from the mains power supply and from all other
devices if fault occurs
Install the power supply unit and the unit only in a dry place protected against the
elements
If you are uncertain about the safe operation of the unit, shut it down immediately
and secure it to prevent any unauthorized start-up. Safe is no longer possible, for
example:
Installation and operation
All applicable electrical codes and regulations must be observed and followed at all
times during the installation.
Before installing or operating the system, ensure that you have read and
understood the documentation for other equipment connected to the unit, e.g.
monitors or pan-tilt heads. These contain important safety notices and information
concerning permissible applications.
Perform only installation and operating work described in this manual. All other
work beyond this may lead to injuries to persons and damage to the system or
other equipment.
Ensure a secure footing whenever working in elevated positions. Use only safety
ladders. If necessary, use safety harness or railings.
Use this camera with original Ganz tools.
Repairs and maintenance
Never open the housing of the unit.
Never open the housing of the power supply unit.
Ensure that only qualified, specialist personnel are permitted to carry out
maintenance or repair work.
Contact your dealer for authorized reparation.
If damage is visible to the unit or the cables
If the unit no longer operates correctly
If the unit has been exposed to rain or moisture
If objects have penetrated inside the unit
After long storage under improper conditions or
After heavy demands during transport
ENG- 5