Programming Options - Autostart AS-1820 FM Installation Manual

Automatic transmission remote starter

Hide thumbs Also See for AS-1820 FM:

Wiring schematic (1 page)

User manual (8 pages)

Table Of Contents

Table of Contents

2. Press and hold the Brake Pedal,

– And press one of the following buttons on the Transmitter:

•

..................to access Mode 1;

LOCK

•

..............to access Mode 2;

UNLOCK

•

................to access Mode 3.

TRUNK

The Parking Lights will flash and the horn will honk once, twice or three times to

confirm entry into a Mode (if it has been configured).

3. Release the Brake Pedal.

Note

The Unit will stay in the selected programming

Mode until the Hood Pin-switch or the Brake Pedal

is pressed again. Therefore take your time to

make the proper selection. Pressing the Brake

Pedal will take you back to the Programming

Centre, where you can select a different Mode.

Once you access a particular programming Mode, you will automatically start at Function 1.

Once you select one of the Options of Function 1, you will automatically be taken to the next

Function.

To select one of the four Options of any given Function, press the corresponding button

on the Transmitter:

•

button .........................to access Option 1

LOCK

•

button .....................to access Option 2

UNLOCK

•

button .......................to access Option 3

TRUNK

•

START/STOP

In each Function, once an Option has been selected the Parking Lights will flash 1, 2, 3 or 4

times (depending on the selected Option).

Please note that the different Functions within any particular Mode can only be accessed

sequentially: the Programming Centre will move from Function 1 to Function 2, then to

Function 3, and so on. Therefore, whenever you access a particular Mode, be prepared to

re-configure all the Functions of that Mode in ascending order.