D-Link DCS-6112 User Manual page 31

Configuration
Click Sensor Settings to open the Sensor Settings page. You can set the Maximum
exposure time, Exposure level, and Max Gain (Auto Gain Control) setting.
Exposure
• Maximum Exposure Time: Select a proper maximum exposure time according
to the light source of the surroundings. Shorter exposure times result in less
light reaching the sensor. The exposure times are selectable for the following
durations: 1/5, 1/15, 1/30, 1/60,1/120,1/240,1/480 second.
• Exposure level: You can manually set the Exposure level which ranges from 1 to
8 (dark to bright).
• Max. Gain (Auto Gain Control): You can manually set the AGC level (2X 4X, or
8X). The higher the value, the brighter the image will be.
• Enable BLC (Back Light Compensation): Enable this option when the object
is too dark or too bright to recognize. It allows the camera to adjust to the best
light conditions in any environment and automatically give the necessary light
compensation.
You can create two sets of sensor settings:
For example, you could use Profile 1 for normal situations, and create a Profile 2 for
special situations that may require Schedule mode or Night mode*.
* Night mode applies to the DCS-6113 only.
You can click Preview and fine-tune the image. Click Restore to go back to the
original settings without incorporating any changes. Click Save to save your settings,
and click Close to exit the page.
To configure another sensor setting, click Profile 2 and follow the steps below:
1. Click Enable this profile.
2. Select the applied mode: Day mode, Night mode, or Schedule mode. If you
choose Schedule mode enter a range of time in hours and minutes.
3. Configure Exposure setting in the second column.
4. Click Save to enable the setting and click Close to exit the page.
D-Link DCS-6112 /6113 User Manual 31