Camera Configuration Menu (Control Options) - Settings Of Dome - urmet domus Easy Dome 1092/679 User And Installation Manual

5.5.3 CAMERA CONFIGURATION MENU (CONTROL OPTIONS) – SETTINGS OF DOME
From the first level menu, choice <CONTROL OPTIONS> to select the options concerning dome displaying modes and
motions.
Option
DOME ADDR SETUP
AUTO FLIP
PROPORTIONAL SPEED
PAN REVERSE
TILT REVERSE
V-SCAN STILL
AUTO FOCUS
AUTO AE
VECTORSCAN AF
DS1092-229
1 Dome Addr Setup
2 Auto Flip
3 Proportional Spd
4 Pan Reverse
5 Tilt Reverse
6 V Scan Still
NEXT PAGE
7 Auto Focus
8 Auto AE
9 VectorScan AF
10 -5 Tilt Limit
11 Speed Limit
12 Irled control
13 Return
Value
ON/OFF
ON/OFF
ON/OFF
ON/OFF
NA
Z/PTZ/OFF
Z/PTZ/OFF
NA
CONTROL OPTIONS
ON
ON
ON
ON
NA
PTZ
PTZ
OFF
OFF
OFF
Explanation
Makes it possible to assign the type of addressing and address to
the Dome (see below)
When this option is on, the movements of a subject moving
underneath the camera can be followed by moving the joystick
vertically only. This is possible because after reaching vertical
position, the camera will automatically pan by 180 degrees to be
repositioned and resume the tilt stroke.
If this mode is active, the pan and tilt speed applied by the
keypad is proportion to the set zoom so that the movement speed
decreases when the zoom increases.
If this mode is activated (ON), the joystick commands for pan
function are reversed.
If this mode is activated (ON), the joystick commands for tilt
function are reversed.
NOT AVAILABLE
If activated, the Dome will automatically perform the control of
images focusing. If activated with PTZ, the Dome will perform the
focusing only during the use of Pan, Tilt and Zoom functions. If
activated with Z, the Dome will perform the focusing exclusively
by using the zoom function.
If activated, the Dome will automatically perform the image
exposure control. If activated with PTZ, the Dome will perform the
control only when using the Pan, Tilt and Zoom functions. If
activated with Z, the Dome will perform the control exclusively by
using the zoom function. You can manually change the exposure
value using the direct command on the keyboard 60 + PRESET
(1092/621) or PRESET + 60 + ENTER (1092/623). If the option
was set with PTZ, the iris control returns to auto mode as soon as
you use the keyboard joystick.
NOT AVAILABLE
16