ACT ACTpro Operating And Installation Instruction page 2

ACTpro 120e PSU Operating and Installation Manual
ACTpro 120e PSU Installation Guide
The ACTpro 120e is a single door station with an integrated 12V DC 2A power supply. It
expands any of the existing ACTpro controllers (ACTpro 4000, 4200, 1520e, 1500e) by
one door.
The 2A output current is used to power
the door station and supply the battery
recharge current. 500mA is reserved for
battery recharge and to power the door
station. Therefore 1.5A is available to power
readers and the lock.
See "Installation Instructions" on page 6.
Example: Power budget of a typical single door read in/out installation.
Total Current Available
ACT Door Station and Battery Recharge
ACT Reader X 2
Typical Mag Lock
Total Consumption
Spare Capacity
Electrical Specifi cation
Input Voltage
Frequency
Input Fuse
Output Voltage
Max Load
Electronic Output Fuse
Battery Current
Battery Protections
Operating Temperature
1
2000mA
500mA
200mA
800mA
1500mA
500mA
230VAC +/- 10%
47-53Hz
625mA 250V anti-surge fuse
13.65V (+/-5%)
2A @ 25°C
Yes
~0.5A for a battery discharged to ~10V.
Deep Discharge/Over Charge/Reverse Polarity
-10°C to +50°C