Configuration Of Vrrp - Hirschmann Power MICE User Manual

VRRP/HiVRRP

5.1.1 Configuration of VRRP

The configuration of VRRP requires the following steps:
Switch on routing globally (if this has not already been done).
Switch on VRRP globally.
Configure port - assign IP address and network mask.
Switch on VRRP at the port.
Create virtual router ID (VRID), because you have the option of activating
a multiple virtual routers for each port.
Assign virtual router IP address.
Switch on virtual router.
Assign VRRP priority.
enable
configure
ip routing
ip vrrp
interface 2/3
ip address 10.0.1.1
255.255.255.0
routing
ip vrrp 1
ip vrrp 1 mode
ip vrrp 1 ip 10.0.1.100
ip vrrp 1 priority 200
You configure every port at which VRRP will be active in the same way.
You also perform the same configuration on the redundant router.
Routing L3E
Release 4.2 08/08
Switch to the Priviledged EXEC mode.
Switch to the Configuration mode.
Switch on the router function globally.
Switch on VRRP globally.
Select the port for setting up VRRP.
Assign the port its IP parameters.
Activate the router function at this interface.
Create the VRID for the first virtual router at this
port.
Switch on the first virtual router at this port.
Assign virtual router 1 its IP address.
Assign virtual router 1 the router priority 200.
5.1 VRRP
45