Configuring Interface Tracking - Hirschmann Power MICE User Manual

Tracking

4.2.1 Configuring interface tracking

Set up interface tracking at port 2.3 with a link down delay of 0 seconds
and a link up delay of 3 seconds at port 1.1.
Select the Routing:Tracking:Configuration dialog.
Click on "Create" at the bottom of the dialog.
The interface changes to the input dialog.
Enter the values you desire:
Track ID: 1
Type: interface
Link up delay: 3
Link down delay: 0
Module port: 2.3
Click on "Set" at the bottom of the input dialog.
The interface goes back to the
Routing:Tracking:Configuration dialog and sets up the
new tracking object.
enable
configure
track 1 interface 2/3 link-
down-delay 0 link-up-delay 3
Tracking ID 1 created
terface set to 2/3
sec Link Up Delay for target interface set to 3 secTracking ID 1
activated
exit
show track
ID Type Intf Down Up
-- ---- ---- ---- ----- ------ ------ ------- -------------------
1 Intf 2/3
Unconfigured Track-IDs with registered applications:
----------------------------------------------------
40
Tracking type set to Interface
Link Down Delay for target interface set to 0
Link Delay
Status Mode Changes Time since last change
0s 3s DOWN
4.2 Configuring the tracking
Switch to the Priviledged EXEC mode.
Switch to the Configuration mode.
Enter the tracking parameters and activate this
tracking object.
Switch to the Priviledged EXEC mode.
Display the configured tracks
No. of
Enable 0
Target in-
0 day(s), 00:00:29
Routing L3E
Release 4.2 08/08