LRI6E CERAMIC BURNER REMOVAL / INSTALLATION
REMOVAL
1) Remove left and right side panels by sliding them forward - see below.
2) Lift the Burner slightly while pulling forward to clear the mixing tube.
3) To install - reverse Steps 2 and 1.
INSTALLATION
Care must be taken when installing the burner into the firebox.
Do not damage, knock or scrape the pilot assembly.
The flame sensor and ignition lead are fragile and can be damaged
*Satin black paint is included if touch ups are required.
Important Note:
A correctly installed burner - the burner is back far enough, lower
the front edge so that the front flange of the burner (underneath)
sits down into the grooves in the burner mounting brackets Left
and Right. There will be a small gap between the Ceramic Burner
and the firebox Bottom Flange. The Burner should be situated
about ¼" (6mm) inside the front edge of the firebox.
6mm
LRI6E / HRI6E Direct Vent Gas Insert
maintenance
easily.
|
45
| 45