installation
|
36
BACKING PLATE INSTALLATION
1. Remove Vignette faceplate from unit and lay on a soft surface.
2. Remove the outer faceplate by removing the 5 screws as shown.
Note: the two top and two bottom screws can be loosened - slide the
outer faceplate up on out to remove.
919-663
36 |
LRI6E / HRI6E Direct Vent Gas Insert
BACKING PLATE INSTALLATION
1
3. Attach the backing plate to the outer faceplate from the front with 7
screws (3 along the top and 2 on each side).
4. Reinstall the outer faceplate and backing plate—reverse Step 2.
5. Reinstall the Vignette faceplate and safety screen to complete.
Final Install
4E/6E
05.18.16